need help?
[email protected]
Knife Maker's Center Line Scribe, Block Scribe, 2 X 72 Knife Grinder Scribe
$10.55 $17.59
- Product Code:
- Availability: 233
- Price in reward points: 16253
- 1000 Units in Stock
- All returns accepted:Returns Accepted
- Restocking Fee:No
- Condition:New
- Item must be returned within:60 Days
- Refund will be given as:Money Back
- Return shipping will be paid by:Buyer
This is a New Knife Maker's Center Line Block
Scribe
. These are used the same way you would use a height gauge. The body is made from 6061 Grade Aluminum bar stock. The dimensions are 1" X 1" X 2" long. There is a V shaped groove milled into the body to accept the 1/8" carbide rod. The thumb screw is solid brass and is threaded 1/4"-20. The tungsten carbide rod has a beautifully ground point on one end and a slight chamfer on the back end. The aluminum body has a 1/4"-20 threaded thru hole in it to accept the thumb screw. A new style heavy machined aluminum washer under the thumb screw secures the carbide rod in the block's V-groove. This scribe will adjust from Zero to a little over 1/4" high so you can use it to mark the center of a piece of stock up to at least 1/2" thick. These are simple and easy to use to make a single or the dual lines which many prefer. Either way always mark your stock from both sides of your work. Made in The USA in a Small New Hampshire Shop.
Please note:
This auction is for the aluminum block, tungsten rod, washer and brass thumb screw as seen in the last photo.
The knife blank, ruler, and steel stock is NOT included.
Scribe
. These are used the same way you would use a height gauge. The body is made from 6061 Grade Aluminum bar stock. The dimensions are 1" X 1" X 2" long. There is a V shaped groove milled into the body to accept the 1/8" carbide rod. The thumb screw is solid brass and is threaded 1/4"-20. The tungsten carbide rod has a beautifully ground point on one end and a slight chamfer on the back end. The aluminum body has a 1/4"-20 threaded thru hole in it to accept the thumb screw. A new style heavy machined aluminum washer under the thumb screw secures the carbide rod in the block's V-groove. This scribe will adjust from Zero to a little over 1/4" high so you can use it to mark the center of a piece of stock up to at least 1/2" thick. These are simple and easy to use to make a single or the dual lines which many prefer. Either way always mark your stock from both sides of your work. Made in The USA in a Small New Hampshire Shop.
Please note:
This auction is for the aluminum block, tungsten rod, washer and brass thumb screw as seen in the last photo.
The knife blank, ruler, and steel stock is NOT included.
